Vlastnosti editoru schemat a PCB (bylo: Re: Kicad)

[Robert Baranka]

----- Original Message ----- 
From: "Jirka" <zaloha na volny.cz>
To: <hw-list na list.hw.cz>
Sent: Saturday, February 14, 2015 12:14 PM
Subject: Re: Vlastnosti editoru schemat a PCB (bylo: Re: Kicad)


...
No a k tomu, abych zkusil nejakeho Cinana nebo pool servis Pragoboardu
apod.  na "profi" PCB mi jaksi chybi potrebne znalosti na prevod z Eagle
ci neceho jineho do Gerberu a tech vsech souvisejicich zalezitosti tak,
aby vse "klaplo"...
...
Jirka

Z Vasich prispevkov predpokladam, ze klikat dokazete a cam mate "predzuvane" 
priamo od vyrobcov dps:

itead: 
http://support.iteadstudio.com/support/solutions/articles/1000156317-gerber-files-requirements
a potom upload: 
http://support.iteadstudio.com/support/solutions/articles/1000156323-how-to-upload-gerber-files

Pragoboard to ma horsie - "predzuvany" ma len pre Eagle, navody aj pre ine, 
Kicad chyba:
http://www.pragoboard.cz/soubory a potom e-mail

Vygenerovane subory si mozete skontrolovat - pouzivam starucke GC-Prevue 
(starucke bezi stale, nove sa musi po aktualizacii preinstalovat)
Isto by ste to zvladli.
Robo