Civka na plosnaku - vypocet - e*a*g*l*e
Jaroslav Lukesh
lukesh
Středa Březen 17 14:53:00 CET 2004
| Odes?latel: Jakub Ladman <ladmanj@volny.cz>
| Jak se to ULP jmenuje ? Je to ve standardni vybave Eaglu? Nebo kde to
| stahnout?
asi spiral.ulp (ja si ho totiz prejmenoval)
| Predstavoval bych si vymezit plochu a zadat indukcnost a ten ULP by se
| to pokusil nakreslit.
Mno Tolik toho neumi... Tohle je v tom ULP:
// Parameterliste -- parameter section
real n = 6.4; // Windungen
// number of turns
real Durchmessermm = 11.0; // in mm siehe E
// mm see E
real Wickelbreitemm = 4.5; // in mm siehe d
// mm see d
real Wirewidthmm = 0.3; // Leiterbahnbreite im mm
// track width
real Wiredistmm = 0.2; // min. Abstand der Leiterbahnen
// min. distance between tracks
real Diameter = 1.2; // Pad/Via-Durchmesser
// pad/via diameter
real Drill = 0.6; // Bohrduchmeser
// drill diameter
This ULP calculates a coil using the parameters defined in the section
above and generates a script file (SPIRAL.SCR).
In case of invalid parameter input the script file contains an error
message containing a hint what the error could be. Change the parameters
then and run the ULP again.
Depending from where you are starting the ULP, the script file
places pads (library) or vias (board).
|<-------E-------->|
| |
| __________
| / _______ \
/ / ___ \ \
| / / _ \ | |
| | / / \ | | |
| | | O | | | O
| | | | | |
| | \_____/ | |
| \ ________/ | |
\_____________/ |
|
| |
|<--d-->|
JL.
Další informace o konferenci Hw-list