3D print materialy

[Kubat Tomas]

v nejhorsim(PET-G) 1g/1kc, to neni nic hrozneho.
tomik.

-----Original Message-----
From: Hw-list [mailto:hw-list-bounces na list.hw.cz] On Behalf Of Petr Simek
Sent: Monday, February 26, 2018 12:07 PM
To: HW-news <hw-list na list.hw.cz>
Subject: Re: 3D print materialy

On Mon, 26 Feb 2018, balu wrote:

> nie je to nic specialne. Krabica ca. 20x20x7cm, na stol do dielne. 
> Nejaka neutralna technicka farba.
> Vo vnutri krabice vykonova strata asi 5W, vetracie otvory su uz 
> integrovane.

Nebylo by lepsi koupit desku POMC (nebo neceho podobneho), narezat (ci nastrihat) z ni strany a na tiskarne si vytisknout jen rohy do kterych se ty desky vlepi ?

Ten plast neni uplne levny, spotrebuje se ho docela dost a trva to dlouho nez se to vytiskne.

> b.


*------------------------------------------------------------------------*
|                          Petr Simek   APS JU                           |
|                             psimek na jcu.cz                              |
*------------------------------------------------------------------------*
_______________________________________________
HW-list mailing list  -  sponsored by www.HW.cz Hw-list na list.hw.cz http://list.hw.cz/mailman/listinfo/hw-list