STM32F439 problem s LCD + ETHERNET

[Jan Waclawek]

> Note: Ethernet works properly in the default setting (which RX_ER is not connected to PI10 of
> STM32F439NIH6) because PI10 is shared with data signal of SDRAM. If RX_ER signal is
> needed, remove R244 and solder R43.

Toto je pre mna ako po hebrejsky - co tym chcel basnik povedat? Ak
MII_RX_ER z PHY *nie je* defaultne zapojeny, preco by malo platit ze
"Ethernet works properly"? A ak tomu dobre rozumiem, tak na tej doske
nejde naraz pouzivat ETH_MII a SDRAM?

wek


PS. http://list.hw.cz/pipermail/hw-list/2014-October/463445.html - a este
mne nadavaju, ze moj mailovy klient mrsi maily... :-)