zasekavajici SPI na atmega8

[Lukas Burda]

Jinak program jede normalne dal. Jen se na SPI nic neposila a
nenastavuje se SPIF.



Thursday, January 2, 2014, 1:26:09 PM, you wrote:

> No, nemam. Ale nikdy jsem nemel a nikdy problem nebyl. Moc se mi
> nezda, ze by to bylo timhle.



> Thursday, January 2, 2014, 1:12:16 PM, you wrote:

>> Mate na tom resetu nejaky kondik proti GND (pak by to chtelo jeste diodu
>> paralelne k odporu)?

>> Martin Hanek

>> Dne 2.1.2014 12:59, Lukas Burda napsal(a):

>>> --
>>> Reset je normalne mechanicky RESET na low, nebo od programatoru,
>>> pullup na resetu je 22k na napajeni 5V.
>>> fuses jsou podle http://www.engbedded.com/fusecalc pro atmega328:
>>> lfuse:0xe2 hfuse:0xd9 efuse:0xff
>>> cili int. oscilator, spien ON (cele to programuju pres spi, takze spi je
>>> snad zadratovane ok), wdtimer OFF, Brown-out detector OFF.
>>>
>> _______________________________________________
>> HW-list mailing list  -  sponsored by www.HW.cz
>> Hw-list na list.hw.cz
>> http://list.hw.cz/mailman/listinfo/hw-list

> _______________________________________________
> HW-list mailing list  -  sponsored by www.HW.cz
> Hw-list na list.hw.cz
> http://list.hw.cz/mailman/listinfo/hw-list