Pripojeni GPS modulu k AIS radaru

[Miroslav Šinko]

standard pre NMEA je 4800Bd

miro

Dňa 4.10.2010, peter tesar <peter.tesar na centrum.sk> napísal(a):
> Zdravim,
> ja pouzivam k AIS prijimacu (pripojenom k PC cez RS232) GPS Navilock
> pripojeny cez USB (v podstate cez RS232 cez zabudovany USB-to-RS232
> prevodnik). Vsetko musi byt na rovnakom protokole NMEA (to treba nastavit v
> konfiguracnom programe ku GPS, casto totiz GPS prijimace komunikuju
> prednostne v nejakom proprietarnom protokole, ale zatial vsetky co som mal v
> rukach vedia prepnut aj do NMEA). Musi to byt aj na rovnakom bitrate (tusim
> 38400).
> Nerobi to ziadne problemy, ten NMEA protokol je jednoduchy a do praxe
> vyborny.
> Peter Tesar.
>
>
> RV wrote:
> > Zdravim,
> >
> > mozna trochu neobvykly dotaz, ale nema nekdo zkusenost s AIS radarem a
> pripojenim GPS modulu?
> >
> > Konkretne s timto zarizenim:
> > http://www.nasamarine.com/proddetail.php?prod=AIS_radar
> >
> > Privezl jsem to i s lodi ale chybi prijimac GPS a v manualu pisou jen:
> >
> > Connect the NMEA output (or NMEA +) of the GPS to the BLUE
> > wire of the UTILITY cable. If the GPS has a NMEA - or NMEA
> > REF connect this wire to the vessel supply negative. The AIS radar
> > requires an NMEA 0183 signal with RMC sentence. The signal
> > level must swing above and below 2 volts.
> >
> > Myslite ze je pouzitelny treba tento modul:
> http://mobile.itek.cz/moduly-gps-dratove/324801-Navilock-GPS-PDA-prijimac
> >
> >
> >
>
> _______________________________________________
> HW-list mailing list  -  sponsored by www.HW.cz
> Hw-list na list.hw.cz
> http://list.hw.cz/mailman/listinfo/hw-list
>