[OT]: CNC frezka - zapojeni motoru

[Aleš Chlubný]

Myslim elektricke - tzn. seriove nebo paralelne. Potrebuju to vedet kvuli
napajecimu zdroji, protoze pri paralelnim je potreba 2x vetsi proud (alespon
podle pdf k SX23-1012).

S pozdravem,
Ales Chlubny


> -----Original Message-----
> From: hw-list-bounces@list.hw.cz [mailto:hw-list-bounces@list.hw.cz] On
> Behalf Of Pavel Novotny
> Sent: Monday, January 16, 2006 1:03 PM
> To: 'HW-news'
> Subject: RE: [OT]: CNC frezka - zapojeni motoru
> 
> Myslite eletricke nebo mechaniccke zapojeni (prevod , spojka)?
> 
> 
> Dobry den, asi je to hloupa otazka, ale nejak nevim jak je lepsi zapojit
> klasicky bipolarni motor 2Nm pro CNC frezku. Dekuji.
> 
> S pozdravem,
> Ales Chlubny
> 
> 
> 
> _______________________________________________
> HW-list mailing list  -  sponsored by www.HW.cz
> Hw-list@list.hw.cz
> http://list.hw.cz/mailman/listinfo/hw-list
> 
> 
> 
> 
> _______________________________________________
> HW-list mailing list  -  sponsored by www.HW.cz
> Hw-list@list.hw.cz
> http://list.hw.cz/mailman/listinfo/hw-list