Jak pouzit GCK1 pin u SPARTANA

[Jiri Beranek]

Dekuji, uz to slape....

----- Original Message ----- 
From: "Zdenek Aster" <zdenek.aster@seznam.cz>
To: "HW-news" <hw-list@list.hw.cz>
Sent: Monday, July 04, 2005 6:45 PM
Subject: Re: Jak pouzit GCK1 pin u SPARTANA


Zkuste tam pridat
NET "clk"  TNM_NET = "clk"

Pokud to nepomuze, tak jsem poslete VHDL a UCF,
on nekdy Webpack je pri hlaseni chyb docela mimo
hlavne pri synthesize, hlasi tak trosku jinak chyby clovek
si na to musi zvyknout.

Zdenek Aster


----- Original Message ----- 
From: "Jiri Beranek" <beranek@gost-elektronic.cz>
To: <hw-list@list.hw.cz>
Sent: Monday, July 04, 2005 4:06 PM
Subject: Jak pouzit GCK1 pin u SPARTANA


Pomuze mi prosim nekdo co mam napsat, aby mi pin GCK1 u SPATANA
chodil jako vstupni.

Pise mi to tohle:

***************************************************
ERROR:Pack:1107 - Unable to combine the following symbols into a single IOB
component:

PAD symbol "clk" (Pad Signal = clk)

BUF symbol "clk_IBUF" (Output Signal = clk_IBUF)

Each of the following constraints specifies an illegal physical site for a

component of type IOB:

Symbol "clk" (LOC=P91)

Please correct the constraints accordingly.

****************************************************************************
*******

v UCF  souboru mam tohle:

NET "clk" LOC = "P91"  ;
NET "led"   LOC = "P67"  ;



J. Beranek





_______________________________________________
HW-list mailing list  -  sponsored by www.HW.cz
Hw-list@list.hw.cz
http://list.hw.cz/mailman/listinfo/hw-list

_______________________________________________
HW-list mailing list  -  sponsored by www.HW.cz
Hw-list@list.hw.cz
http://list.hw.cz/mailman/listinfo/hw-list