ako na spiralu v OrCAD-e

[Ivan Feno]

Ano, da sa aj tak, mna len zaujimalo,
ci nema niekto nieco "vykoumane".
ivo.

----- Original Message -----
From: Libor Kavan <lkavan@krkonose.cz>
To: Multiple recipients of list <hw-news@list.gin.cz>
Sent: Saturday, June 23, 2001 3:13 PM
Subject: Re: ako na spiralu v OrCAD-e


> At 14:30 22.6.2001 +0200, Ivan Feno wrote:
> >Priatelia,
> >potrebujem nakreslit bezjadrovu cievku (na plosnom spoji)
> >v OrCADe 9. Jedine co sa podarilo je urobit to cez
> >rutovaci nastroj s nastavenim Curve Edges.
> >Avsak spirala nie je zlozena z polkruznic, takze ten
> >vysledok tomu zodpoveda.
>
> A neslo by tu civku udelat ctvercovou ? Ja to tak delal a to se da
nakreslit
> v pohode a navic ctvercova civka je na desce 'skladnejsi' ...
>
> S pozdravem           with best regards
> ------------------------------------------------------------
>                  EZA-TV Vrchlabi
>     Libor Kavan               Phone & Fax:+420 438 521 232
>     Dlouha 421                Fax:+420 438 521 262
>     543 03 Vrchlabi III       mailto:lkavan@krkonose.cz
>     Czech Republic            http://www.krkonose.cz/eza-tv
>  ------------------------------------------------------------
>
>