<!DOCTYPE html>
<html>
<head>
<meta http-equiv="Content-Type" content="text/html; charset=UTF-8">
</head>
<body smarttemplateinserted="true">
<div id="smartTemplate4-template">Ahoj,<br>
<br>
Na panelu kamen jde nastavovat 5 stupňů výkonu. <br>
<br>
Jediné, co v návodu píšou je:<br>
<br>
The STBY clamp leaves the factory jumpered, therefore it is always
with closed contact (on request).<br>
ADDITIONAL THERMOSTAT FUNCTIONING WITH STBY ACTIVE<br>
When the STBY function is activated, the LED flashes. When the
contact or external thermostat is not satisfied (open<br>
contact/temperature reached), the stove will switch off. As soon
as the contact or external thermostat passes to the "not<br>
satisfied" status (closed contact/temperature to reach) it will
re-ignite.<br>
Note: stove functioning depends on the temperature of the water
inside the same and relative factory restrictions set.<br>
If stove is in H OFF mode (water temperature reached), any
additional contact or thermostat request will be ignored.<br>
ADDITIONAL THERMOSTAT OPERATION WITH DEACTIVATED STBY<br>
When the STBY function is deactivated, the LED is fixed.<br>
When the contact or external thermostat is not satisfied (open
contact/temperature reached), the stove will go to minimum.<br>
As soon as the contact or external thermostat passes to the "not
satisfied" status (closed contact/temperature to reach) the<br>
stove will start to work again at the pre-set power.<br>
<br>
Takže pokud se kontakty rozpojí, tak by měl jet kotel na nějaký
minimální výkon, a po sepnutí to opět rozjet na nastavený stupeň
výkonu.<br>
V tom případě by ale kamna asi topila stále, na minimum, i když by
to nebylo potřeba.<br>
<br>
--<br>
Aleš Filip<br>
<i><a class="moz-txt-link-freetext" href="http://xanadu.khnet.info">http://xanadu.khnet.info</a></i></div>
<div id="smartTemplate4-quoteHeader"><br>
Původní zpráva od Ajtservis:</div>
<blockquote type="cite"
cite="mid:320c6979-1f43-71ba-db7d-c86a271144fc@ajtservis.cz">jen
takovej tip, neni tam regulace vykonu ? tedy ne on/off, ale treba
20 - 100% .
<br>
t.
<br>
<br>
Dne 16.10.2023 v 11:48 Aleš Filip napsal(a):
<br>
<blockquote type="cite">Ahoj,
<br>
<br>
Netopíte někdo kotlem nebo kamnama na pelety? Chtěl bych k
tomu připojit externí termostat, ale nějak si nedovedu
představit, jak se to bude chovat.
<br>
U kotle na plyn/elektriku je to jasné. Tam to zapíná/vypíná
podle teplot. Ale tohle se po vypnutí ještě 20minut hasí, čistí,
atd. Nějak si nedovedu představit co to udělá, když v té době
termostat znovu zapne. Než s tím začnu laborovat, tak hledám
nějaké informace, ale bohužel jsem nikde nic nedohledal. Ale ten
externí termostat k tomu připojit jde. Z kamen jsou vyvedené ven
2 kontakty, které jsou teď zkratované propojkou.
<br>
(kamna jsou Extraflame Iside Idro)
<br>
--
<br>
Aleš Filip
<br>
/<a class="moz-txt-link-freetext" href="http://xanadu.khnet.info/">http://xanadu.khnet.info/</a>
<br>
<br>
_______________________________________________
<br>
HW-list mailing list - sponsored by <a class="moz-txt-link-abbreviated" href="http://www.HW.cz">www.HW.cz</a>
<br>
<a class="moz-txt-link-abbreviated" href="mailto:Hw-list@list.hw.cz">Hw-list@list.hw.cz</a>
<br>
<a class="moz-txt-link-freetext" href="http://list.hw.cz/mailman/listinfo/hw-list">http://list.hw.cz/mailman/listinfo/hw-list</a>
<br>
<br>
</blockquote>
<br>
</blockquote>
<br>
</body>
</html>