STM32F051 zvlastne spravanie sa USART FLAGov

[Stano]

Mate pravdu za ten RXNE naozaj mohol debugger.
Ten druhy bug bol ale omnoho zakernejsi, bohuzial tiez sedel medzi 
klavesnicou a stolickou.

Dakujem vsetkym za snahu pomoct
       Stano

Tomas Dresler  wrote / napísal(a):
> Wek mel urcitena mysli IDE. Pri breakpointu v preruseni, pokud mate 
> periferii v Register view, si debugger ty registry precte a protoze 
> debugger je jen jeden z masteru na sbernici, periferie netusi, zda ji 
> precetl debugger nebo program, a poslusne ty flagy smazne :-)
>
> Takze vyhodte UART z Peripheral view a problem zmizi sam :-)
>
> Tomas
>
> On 2015-03-18 19:55, Stano wrote:
>> Bol pripojeny ale neaktivny, jeho piny v HiZ
>> To iste aj s odpojenym debuggerom po napaleny vypnute napajanie a
>> znovu zapnut takze nepredpokladam ze by sa nieco "zabudlo: zapnute.
>> Delay som simuloval cyklom.
>> volatile uint32_t t;
>> for(t = 0; t < 1000000; t++);
>>
>>
>> Jan Waclawek  wrote / napísal(a):
>>>> Bohuzial, ked si namiesto debuggera dam do spomenutych casti 
>>>> set/clear GPIO chova sa to totozne.
>>>>
>>>
>>> A je pri tom ten debugger pusteny/pripojeny?
>>>
>>> wek
>>>
>>> _______________________________________________
>>> HW-list mailing list  -  sponsored by www.HW.cz
>>> Hw-list na list.hw.cz
>>> http://list.hw.cz/mailman/listinfo/hw-list
>>>
>>
>> _______________________________________________
>> HW-list mailing list  -  sponsored by www.HW.cz
>> Hw-list na list.hw.cz
>> http://list.hw.cz/mailman/listinfo/hw-list
>
> _______________________________________________
> HW-list mailing list  -  sponsored by www.HW.cz
> Hw-list na list.hw.cz
> http://list.hw.cz/mailman/listinfo/hw-list