Kicad

[Jaroslav Buchta]

No, funguje to i pod Windows ;-)

Kazdopadne na kontrolu podkladu PCB staci ten zabudovany gerber viewer, 
umi zobrazit i vrtani a kdyz to na sobe vsechno sedi, je to pro Cinu i 
Pragoboard OK.

Dne 17. 2. 2015 v 10:09 Zuffa Jan napsal(a):
> Tak som stiahol, poskusal
> a po 2  hodinach som bol schopny nakreslit jednoduchu schemu,
> plosak, vytvorit vlastne puzdro. Vcelku intuitivne a hlavne rychle
> (testovane na 7 rocnom ntb s WXP)
> Takze dalsi bod mam splneny pre uspesne opustenie platformy Windows
>
> :)
>
> j.
>
> -----Original Message-----
> From: Hw-list [mailto:hw-list-bounces na list.hw.cz] On Behalf Of balu na home
> Sent: Friday, February 13, 2015 7:44 PM
> To: hw-list na list.hw.cz
> Subject: Kicad
>
> nas prispevok ku lacnejsiemu chlebu po ktorom volaju danovi poplatnici z celej Europy :-)
>
> http://cds.cern.ch/journal/CERNBulletin/2015/08/News%20Articles/1988318?ln=en
>
> Next week, the team is going to release two new features that many in the free/Open Source EDA community have been asking for: differential pair routing and trace length matching.
> _______________________________________________
> HW-list mailing list  -  sponsored by www.HW.cz Hw-list na list.hw.cz http://list.hw.cz/mailman/listinfo/hw-list
> _______________________________________________
> HW-list mailing list  -  sponsored by www.HW.cz
> Hw-list na list.hw.cz
> http://list.hw.cz/mailman/listinfo/hw-list


---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com