OT: FLAME: Samba na linuxu - problem s rychlosti

[CNCnet.info]

problem je ze mi ta negociace nejde nejak vypnout:

tull@cncnet2:~$ sudo mii-tool eth0
eth0: negotiated 100baseTx-FD flow-control, link ok
tull@cncnet2:~$ sudo ethtool -s eth0 duplex full speed 100 autoneg off
tull@cncnet2:~$ sudo ethtool eth0
Settings for eth0:
        Supported ports: [ TP ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Supports auto-negotiation: Yes
        Advertised link modes:  100baseT/Full
        Advertised auto-negotiation: Yes
        Speed: 100Mb/s
        Duplex: Full
        Port: Twisted Pair
        PHYAD: 0
        Transceiver: internal
        Auto-negotiation: on
        Supports Wake-on: pumbg
        Wake-on: g
        Current message level: 0x00000033 (51)
        Link detected: yes
tull@cncnet2:~$

rychlost dokazu bez problemu prepnout, ale stale to pise 
Auto-negotiation: on

S tim IPV6 to asi nijak nesouvisi - to byl jen zapnuta podpora na ftp 
serveru a prave rval, ze nema nic dostupneho.

Radek Vicek 
======================================================================
http://www.cncnet.info - problematika CNC a automatizace
http://www.jakjevenku.info - webová meteostanice



ladmanj@volny.cz napsal(a):
> Na nekterych sitovkach ethtool, na nekterych mii-tool, kazdy program
> umi jinou mnozinu sitovek, nektere jdou nastavit obema.
>
> Taky se to da nastavovat parametrama pri zavadeni modulu ovladace do
> jadra, mrknete se do zdrojaku ovladace, to je pro mne jedinna znama
> cesta k tem informacim, ale mozna existuje i nejaka uzivatelstejsi.
> Jakub Ladman
>   
>