Re: [ EAGLE ] / Vytvorenie súčiastky - prepoje

[Michal HW]

Na kresleni schemat to chce grid 1,27mm tedy palcovy.
Net musí končit presne na vyvodu, jinak se to nanapoji.
V modulu brd - kresleni DPS, si program rozdily Gridu umi dokreslit.
Michal
----- Original Message ----- 
From: "Kalin.Oleg" <Kalin.Oleg@seznam.cz>
To: "HW-news" <hw-list@list.hw.cz>
Sent: Saturday, March 04, 2006 11:57 AM
Subject: Re: [ EAGLE ] / Vytvorenie súčiastky - prepoje


to samozrejme mam. opticky je pripojeny net v pine, na boarde vsak nie je.
a ERC pise pin overlaps...

OK


----- Original Message -----
From: "balu@home" <daniel.valuch@wanadoo.fr>
To: "HW-news" <hw-list@list.hw.cz>
Sent: Saturday, March 04, 2006 11:54 AM
Subject: Re: [ EAGLE ] / Vytvorenie súčiastky - prepoje


zapni si hladinu "pins" a uvidis kam mas pripojit net aby bol korektne
pripojeny
b.


Kalin.Oleg wrote:

>grid som nastavil na 0,5mm, to sa nesmie?
>
>potreboval som umiestnit 11 padov do kruhu.
>
>ERC:
>WARNING: Sheet 1/1: unconnected Pin: R2 1
>WARNING: Only 1 Pin on net N$1
>WARNING: Sheet 1/1, Net N$1: wire overlaps pin at (1.8 2.106693)
>
>problem je asi v pinoch, ale neviem aky...
>
>alebo naozaj v tom gride?
>
>OK
>
>
>


_______________________________________________
HW-list mailing list  -  sponsored by www.HW.cz
Hw-list@list.hw.cz
http://list.hw.cz/mailman/listinfo/hw-list

__________ Informacia od NOD32 1.1429 (20060303) __________

Tato sprava bola preverena antivirusovym systemom NOD32.
http://www.eset.sk



_______________________________________________
HW-list mailing list  -  sponsored by www.HW.cz
Hw-list@list.hw.cz
http://list.hw.cz/mailman/listinfo/hw-list